Tag Archives: Hand made lamp

Knap Lamp

The first thing you notice about this lamp is that when it is on, the wooden balls seem to float mysteriously in the center of the lamp.   Remarkably, that is how the lamp is turned on and off.  For now I’ll show you the wood working involved, leaving the mystery switch to your imagination.

Knap is a word in the Dutch language that translates variously to clever, good looking, smart, handsome, or bright.  All words that describe this continuing project.  There will be more designs coming soon that will incorporate this switch design.  This is the first.

To make the frame to hold the LED lights I selected a nice hard maple board and began cutting, forming, and finally mitering and joining the pieces to for an octagon.

The mitered joints are made structurally sound by using carefully designed splines, two at each joint.  Lots of cutting and fitting, but it works well for strength and looks nice too.

I needed lenses to cover the LED’s and they were made from 1/8″ milky white translucent cast plexiglass.  That comes covered in protective paper on both sides so you can cut and fit it without putting scratches in it.

The base holds the wiring and power supply for the LED’s.  It is just a basic box made with miter corners to hide all end grain.  There is a separate top frame to mount the upper framework.

Final sanding and then two coats of stain followed by three coats of poly for the finishing touch.

This is “special walnut” on hard maple.

Finally the wires are all connected, the switch strings and wooden balls installed and it is ready to go.  The lower ball has a special resting place when the lamp is off.

It has a mysterious and elegant look, especially when turned on.